User's Manual

www.art-tech.com
09
Press the menu button, enter into the Cuv menu (there are 4 submenu
included: Thr, Pit, T3d, P3d). Switch on the 3D switch, the 3D curve can be
activated.
4.1 Normal Throttle settings:
1. Press the sub button; enter into the Thr menu (Normal throttle curve
function).
2. Press the Left or right button, choose the key point to be set (5 key
points are corresponding to the channel trip of 0% 25% 50% 75% 100%),
press the y / up or n / down button to increase or reduce the value. The
value may be set anywhere between 0% and 100%)
4.2 Normal pitch settings:
1. Press the sub button, enter into the Pit menu (Normal throttle curve function).
2. Press the Left or right button, choose the key point to be set (5 key
points are corresponding to the channel trip of 0% 25% 50% 75% 100%),
press the y / up or n / down button to increase or reduce the value. The
value may be set anywhere between 0% and 100%)
4.3 3D throttle settings:
1. Press the sub button; enter into the T3d menu (3D pitch curve function).
2. Press the Left or right button, choose the key point to be set (5 key
points are corresponding to the channel trip of 0% 25% 50% 75% 100%),
press the y / up or n / down button to increase or reduce the value. The
values set take effect when the 3D switch is switched on. The value may
be set anywhere between 0% and 100%)
4.4 3D pitch settings:
1. Press the sub button, enter into the P3d menu (3D pitch curve function).
2. Press the Left or right button, choose the key point to be set (5 key
points are corresponding to the channel trip of 0% 25% 50% 75%
4.Curve settings
(C mode)
1. Press the sub button to enter the Swash menu (Swash Rate Setting).
The following Figure (1) is 120° CCPM and Figure (2) is 90° CCPM.
Press y/up button or n/down button to choose to connect the aileron to
CH1 or CH6, elevator to CH2, Pitch to CH6 or CH1.
2. Press the left button or right button to choose the right option (A for
aileron, E for elevator, P for pitch). Press the y/up button or n/down
button to increase or decrease the setting value (The value -100% ~ 100%
indicates the actual output mixing rate).
(1) (2)