User's Manual

SK-M30

1. Bluetooth mode

2. Bluetooth version：Bluetooth 3.0，With the prompt, the Bluetooth device name is: AUKEY

SK-M30

3. Long press (2 seconds) switch machine key, can open, shut down. After the boot, the speaker

issued a note, the blue light flashing fast, at this time, the machine into the Bluetooth mode

4. The blue light flashes rapidly pairing, mobile phone search to AUKEY SK-M30 device name

to confirm connection, the connection after the success of the blue light, speaker sounds,

music playback process blue light flash slowly. The first open mobile phone paired bluetooth

mobile phone, then open the box will automatically connect back.。.

II、AUX IN model

1. Boot state, insert the AUX IN line, automatically enter the AUX IN mode, the slow flashing

blue light

2. during the play, the indicator light flashes slowly

III、charge

1. Connect the USB cable into the speaker, connect the 5V charger or the computer to charge the

built-in battery；

2. Charging "charge" indicator light red, filled with red lights out。

IV、

1.All the local mode boot volume default total volume 2/3. to protect the battery life and sound

work, software set battery voltage is lower than 6.5V speakers will automatically detect and voice

alarm, the battery voltage is lower than 6.4V speakers will be issued voice prompt and set

automatic shutdown

2.If the machine is stuck, press the reset button to reset

V、

15.19 Labelling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation.

15.21 Information to user.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

15.105 Information to the user.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

PAGE 1
I SK-M30 1. Bluetooth mode 2. Bluetooth version：Bluetooth 3.0，With the prompt, the Bluetooth device name is: AUKEY SK-M30 3. Long press (2 seconds) switch machine key, can open, shut down. After the boot, the speaker issued a note, the blue light flashing fast, at this time, the machine into the Bluetooth mode 4.
PAGE 2
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between theequipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.