User Manual

SIZE: 70x158mm
FCC NOTICE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV
technician for help.
FCC WARNING:
To assure continued operation, follow the attached
installation instructions and use only shield cables when
connecting to other devices. Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
1
POSSIBLE SOLUTION
Recharge the built-in battery as
page 2.
Increase the volume by press
and holding the Button
Rise the volume level of the
paired/connected device
Reduce the volume level by
press and holding the Button
Reduce the volume level of the
connected/paired device
Pair the external BT Device to
the unit as page 2.
Place the external BT device
close to the unit
POSSIBLE CAUSE
Built in battery drained
Volume of the unit was set
to minimum position
Volume level of
paired/connected device
is in low level
Volume level too high
Volume level of the
connected/paired device
too high
The external BT Device
had NOT paired to the unit
The external BT device
too far from the unit
SYMPTOM
Can’t power on
No sound or
sound weak
Sound
distortion
BT not
functioning
C. Do not charge longer than 24 hours. Excessive charging
or running the unit until battery fully drains will damage
battery. Battery life will be extended if you keep the
battery fully charged.
D. Battery life naturally shortens slowly over time.
E.
The rechargeable battery incorporated in this product is
not user replaceable.
OPERATION:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair
as follows:
1. Power on the unit by pressing and holding the M Button
on the top of the unit approximately 1 second until the
White Indicator on the top of unit is illuminate and blink.
The unit will enter to BT (Bluetooth) mode automatically.
(If Micro SD Card and/ or Audio Connection Cable was
inserted
into the unit. Unplug them from unit before power
on or press the M Button repeatedly to switch to BT mode.)
2. Power on the external BT Device and enter to BT
searching mode. Start pairing following the on screen
instructions from the external BT Device. After paired,
the unit will sound a prompt tone and the White Indicator
will stop blinking.
3. If
pairing is complete you may now play music and answer
calls with your external BT Device.
4. During playback:
● Press the ► Button on the unit to pause, press again
to resume normalplayback.
● Pres
s and holding the or Buttons to adjust volume
level as desired.
● Press and release the or Buttons repeatedly to
skip tracks.
● Press the M Button repeatedly to switch to other
playback mode.
5. If the unit is paired to a Cell Phone and a call is incoming
during an active music session, press the ► Button to
pause the music playback. Then speak to the built- in
microphone
to answer the call. When your call is complete,
press the ► Button to disconnect or end the call and
resume to music playback.
6. When finished listening, press and hold the M Button to
shut off the unit.
3
MODEL: MMA3639
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
OWNER'S MANUAL
®
Craig Electronics warrants this product to be free from
manufacturing defects in material and workmanship
under normal use for a period of 180 days from date of
purchase. If service is required, please return the product
to the store where it was purchased for exchange; or,
pack the unit in the original packing material with all
accessories if applicable, a copy of your sales receipt and
a Cashier’s check or Money Order for $12 (to cover
shipping and handling costs) payable to Craig Electronics
Inc. For consumers in Canada, please make sure that the
cashier check or money order is redeemable through a
U.S. bank. Ship your product freight pre-paid. Your unit
will be repaired, replaced or if the unit cannot be repaired
or replaced, a refund will be forwarded to you within four
weeks of receipt of your unit. Please ship your unit to:
Craig Electronics Inc.
1160 NW 163 Drive
Miami, Fl 33169
This warranty is void if the product has been: a) Used in a
commercial application or rental. b) Damaged through
misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig service center. d)
Damaged because it is improperly connected to any other
equipment.
Note: This warranty does not cover: a) Ordinary
adjustments as outlined in the Owner’s Manual which can
be performed by the customer. b) Damage to equipment
not properly connected to the product. c) Any cost
incurred in shipping the product for repair. d) Damage to
the product not used in the USA.
This warranty is not transferable and only applies to the
original purchase. Any implied warranties, including the
warranty of merchantability, are limited in duration to the
period of this expressed warranty and no warranty
whether expressed or implied shall apply to the product
thereafter.
Under no circumstance shall Craig be liable for any loss or
consequential damage arising out of the use of this
product. This warranty gives specific legal rights.
However, you may have other rights which may vary from
state to state. Some states do not allow limitations on
implied warranties or exclusion of consequential damage.
Therefore, these restrictions may not apply to you.
This product has been manufactured by and is sold under
the responsibility of Craig Electronics Inc, and Craig
Electronics Inc is the warrantor in relation to this product.
MAGNAVOX and SMART. VERY SMART are registered
trademarks of Koninklijke Philips N.V. and are used under
license from Koninklijke Philips N.V.
To Obtain Service on your Product
email:[e-mail]
Printed in China MMA3639_WC_E0FK1_B0WU
LIMITED WARRANTY
Notes:
● When
the external BT Device searched the unit, our model
number “MMA3639” will appear on the display of external
BT Device.
● If while pairing you are asked for a code please try "0000"
or "1234".
Normal operation after pairing:
1. Power on the unit by pressing and holding the M Button
on the top of the unit approximately 1 second until the
White Indicator on the front of unit is illuminate and blink.
The unit will enter to BT (Bluetooth) mode automatically.
(If Micro SD Card and/or Audio Connection Cable was
inserted into the unit, press the M Button repeatedly to
switch to BT mode.)
2. Wait a few seconds until the unit is automatically paired
to the external BT Device
3. After pairing is complete, the unit will sound a prompt
tone and the White Indicator will stop blinking. You may
now play music and answer calls with your external BT
Device.
LINE IN:
To listen
from an external Audio Player such as a MP3 Player,
Discman …etc.
1. Open the Rubber Cover on the rear of unit.
2. Connect one end of the supplied Audio Connection Cable
to the AUX Out/Line Out/Phone Jack on the external
Audio Player.
3. In power on mode, connect the other end of the cable to
the LINE IN Jack as the illustrated below. The unit will
turn to LINE IN mode automatically.
To AUX Out/Line Out/
Phone Jack on the
external Audio Player
4. Play the music on the connected Player as usual. (Make
sure the volume level of the connected Audio Player is
turned to high level.)
5. During playback:
● Press the ► Button to mute the sound, press again to
turn the sound back.
● Press and holding the or Buttons to adjust volume
level as desired.
● Press the M Button repeatedly to switch to other
playback mode.
6. When finished listening, press and hold the M Button to
shut off the unit.
4
Micro SD Card:
1. Open the Rubber Cover on the rear of unit.
2. Insert the Micro SD Card into the Micro SD Card Slot
with contact finger face to up as the illustrated follows:
3. Power on the unit by pressing and holding the M Button
on the top of the unit approximately 1 second. The unit
will plays the song/music on the Micro SD Card
automatically.
4. During playback:
● Press the ► Button to mute the sound, press again to
turn the sound back.
● Press and holding the or Buttons to adjust
volume level as desired.
● Press and release the or Buttons repeatedly to
skip tracks.
● Press the M Button repeatedly to switch to other
playback mode.
5. When finished listening, press and hold the M Button to
shut off the unit.
Notes:
● Up to 16 GB Micro SD Card the unit support to play.
● Before replacing Micro SD Card, make sure the unit has
been powered off.
● When inserting the Micro SD Card, make sure the
direction you selected is correct. Never insert violently to
avoid damaging the Micro SD Card or the unit.
● If it doesn’t work, please check if the direction is correct.
● You also need to download the desired music in MP3
format into the Micro SD Card before insert into the unit.
RESET:
If the unit is halt or abnormal operation, press the
Reset Button by a small screw driver (not included) to
shut it off. Press and holding the M Button approxi-
mate 1 second to power on it again.
5
TROUBLESHOOTING:
Check the following before requesting service:
SPECIFICATIONS:
PACKAGE INCLUDES:
1 x User's Manual
1 x USB Connection Cable (For charge only)
1 x Audio Connection Cables with 3.5mm Plugs
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT
TO CHANGE WITHOUT NOTICE.
6
LOCATION OF CONTROLS:
1.
M Button
2. Button
3. ►Button
4. Button
5. White Indictor
6. Rubber Cover (This cover is for
water and dusts Ingress
Protection;
always make sure it
is completely closed)
7. LINE IN Jack
8. Micro USB Port (For charge only)
9. Micro SD Card Slot
10. Red Charging Indictor
11.
Reset Button (Inside the hole)
12. Built-in Microphone
13. Metallic Buckle
POWER SOURCE:
The unit has a built in Li-ion rechargeable battery, recharge it
before use or when the battery is drained as follows:
1. Open the Rubber Cover on the rear of unit.
2. Connect the Micro USB Plug from the supplied USB
Connection Cable to the Micro USB Port.
3. Connect the full sized USB Plug from the supplied USB
Connection Cable to the USB Port on Computer or USB
Charger (Not included).Charging will automatically start.
● During charging, the Red Charging Indicator on the rear
of unit will illuminate. When finished, it will turn off.
● During charging, you can also play and listen music at
the same time.
To Computer or any USB Charger
NOTES:
The Rubber cover is for water and dusts Ingress
Protection; always make sure it is completely closed.
IMPORTANT:
Your battery will last longer if you're following these simple
guidelines for charging and storing.
A. Before first time use, charge it approximately 4 hours until
the unit is fully charged.
B. Recharge and store the unit within the temperature range
of 5°C~35°(40°F~95°F).
2
Power Source
Dusts/Water Ingress
Protection Level
Impedance of Speakers
Audio Power
BT Version
BT Operation Distance
Built-in DC 3.7V, 1000 mAH(3.7WH) rechargeable Li-ion
battery; Recharge by DC 5V through Micro USB Port
IP67
2 x 5 W; 3 ohm
3W per Channel (Total 6 W, RMS）
4.1
≧ 32 Feet in open area
Portable waterproof Speaker
MMA3639, A023