User's Manual

39285 English I/B ver. 11182A-1
11
11182A-1
OWNER’S MANUAL #
39285
ver.
11182A-1
Page: 11 ENGLISH VERSION
Using the Base unit
• Press the SPK-PHONE button on the
base unit. The Speakerphone LED
Indicator will light up.
• Listen for a dial tone.
• Adjust the speaker volume to your
comfortable listening level.
• Dial the phone number.
NOTE: A confirmation tone will not
“beep” when the handset is returned to the
base unit charging cradle if the
speakerphone mode is active.
Receiving a Call
Using the Handset
If the Handset is on the Base unit
• When the phone rings, lift the handset.
NOTE: While the handset stays on the
base unit charge cradle, the handset
ringer is disabled.
• Start your conversation.
• To end your conversation, either press
the TALK button or place the handset
on the base unit.
If the Handset is out of the Base Unit
• When the phone rings, press the TALK
button. The In Use LED Indicator will
light up.
• Start your conversation.
• To end your conversation, either press
the TALK button or place the handset
on the base unit.
Using the Base Unit
• When the phone rings, press the SPK-
PHONE button.
• Start your conversation.
• Press the Volume Control UP or
DOWN button to adjust the base unit
speaker volume to your comfortable
listening level. The base unit speaker
volume can be adjusted to 8 levels
from the lowest to the highest. A
double “beep” sound will be heard
when you reach the maximum or the
minimum sound level.
NOTE:
• When an incoming call is received,
with the handset away from the base
unit and the ringer switch is set to
“OFF”, the handset will not ring but
the In Use LED Indicator will blink.
Set switch to “ON” for normal use.
• You can turn OFF the base unit ringer
by pressing the RINGER
OFF/TEMPORARY TONE “*”
button. If the base unit ringer is turned
OFF, it will not ring but the base unit
SPEAKERPHONE/INTERCOM LED
indicator will blink when an incoming
call is received. Press the RINGER
ON “#” button to turn ON the base
unit ringer.
• If you are too far away from the base
unit, the handset emits “beep” sounds
to warn you that the background noise
level is too high for proper
communication between the handset
and the base unit. When you hear this
sound, you should move closer to the
base unit to reduce the noise level.
Otherwise, the call will automatically
cut off.
Ending calls
Using the Handset:
Since the unit features “AUTO-
STANDBY”, simply return the handset to
the base unit or press the TALK button if
you are away from the base unit.
Using the Base Unit:
Press the SPK-PHONE button to hang up.
Last Number Redial
If you get a busy tone, use the REDIAL
function to automatically dial the last
telephone number you called.
Redial using the Handset:
• Pick up the handset and press the
TALK button.
• Listen for a dial tone.
• Press RE/PA button to automatically
dial the last telephone number you
called using the handset.
Redial using the Base Unit: