User's Manual

39285 English I/B ver. 11182A-1
9
11182A-1
OWNER’S MANUAL #
39285
ver.
11182A-1
Page: 9 ENGLISH VERSION
H
I
M
I
D
L
O
W
4. Press the two locks located on the side
of the mounting bracket until the
locking hooks snaps into the inner slots
of the base unit as shown in Figure 4.
5. Press the middle locking hooks of the
mounting bracket while pushing the
back of the mounting bracket until it
snaps to lock as shown in Figure 5.
NOTE: Ensure that the lock guide
stays in place on the hole provided on
the base unit as shown in Figure 6.
6. Plug the free end of the short line cord
into the modular wall jack.
7. Align the upper keyhole on the
mounting bracket with the upper stud
of the wall plate, so that the opening
end of the mounting bracket matches
the lower stud, pull the mounting
bracket down until it is securely seated.
(Figure 7)
Wall Mounting (No Standard Wall Jack)
1. Drill two holes with a vertical distance
between the two marked positions of 3
15/16
" (100mm) as shown in Figure 8.
3 15/16"
(100mm)
(Figure 8)
2. Drive a screw into each of the holes.
Tighten them to the end of the screw lines,
only leaving the smooth part of the screw
head outside the wall.
3. Install the wall mount bracket into the
base unit as previously discussed in
Figures 3-6.
4. Hang the unit onto the screws, then
slide it down
firmly
to fasten the base
securely, as shown in Figure 9.
(Figure 9)
Uninstalling the Wall Mount Bracket
To remove the wall mount bracket from
the base unit, pull it back as shown in
Figure 10.
(Figure 10)
H
I
M
ID
L
O
W
Fi
g
ure 3
Fi
g
ure 6
Figure 4
3
Fi
g
ure 5
5
4