User's Manual

Cordless Telephone Operation

Preparing for Use

Before you can use your cordless telephone, you must charge the HANDSET for 12 hours.

Failure to do so will require recharging of the BATTERY PACK more often.

1. Place the HANDSET on the BASE UNIT for 12 hours.

2. After 12 hours, remove the HANDSET from the BASE UNIT.

Before you can use your cordless telephone, you must charge the HANDSET for

12 hours. Failure to do so will require more frequent charging of the BATTERY PACK.

NOTE:

Depending on the frequency of use, once the HANDSET is fully charged, it remains

functional for approximately 7 hours of continuous use and approximately 10 days when the

HANDSET is off the BASE UNIT in STANDBY mode.

1. When the phone rings, the LCD Screen of all of the

HANDSETS registered to the system will display

“Ring.” If you have Caller ID, the LCD Screen will

display the Caller ID information after the first ring.

2. With the HANDSET on or off of the BASE UNIT, press

the button. “Talk” will be displayed and the Call

Timer starts to count. Start your conversation.

3. To end your conversation, either press the button

or place the HANDSET on the BASE UNIT. The

duration of the call will be displayed on the LCD

Screen for about 3 seconds and then returns the LCD

Screen to the STANDBY mode.

TALK

Receiving Calls

When a call is received, all of the HANDSETS registered to the system will ring with the RINGER

LEVEL and MELODY selected by the user. The first HANDSET to respond will get the call.

NOTE:

If you are too far away from the BASE UNIT, the HANDSET emits “beep” sounds to warn you

that the background noise level is too high for proper communication between the HANDSET

and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to

reduce the noise level. Otherwise, the call will automatically cut off.

DSST~MAN~ATC.qxd 4/24/2003 5:14 PM Page 14