User's Manual

Operation

Changing Channels

This set has 14 available channels, To change channels:

1. Press the Mode key the channel number digit will flashes on the LCD

panel.

2. While the channel number is flashing.

* Press the UP ( ) key to increase the channel number.

* Press the DOWN (¨‹)key to decrease the channel number.

3. Press the Mode key twice to select the desired channel.

Note : Refer to the “FRS Channel Table” section of this manual for

detailed frequency listings.(Page 9)

Continuous Tone Coded Squelch System (CTCSS)

CTCSS allows you to hear only specific users, effective blocking out

unwanted calls from other users on the same channel you are using. The

FRS has 38 CTCSS codes available. To set the CTCSS code .

1. Press and the Mode key again the CTCSS code digits will flash on the

LCD Panel.

2. Press the Mode key again the CTCSS code digits will flash on the

LCD Panel.

3. While the CTCSS code is flashing.

* Press are UP ( ) key to increment the CTCSS code.

* Press the DOWN (¨‹)key to decrement the CTCSS code.

4. Press the Mode key or the PTT button/switch to select the desired

CTCSS code.

5. To turn the CTCSS feature off, set the CTCSS code to zero (0).

You will hear everyone in the channel if the CTCSS feature is turned

off.