Manualshelf

User's Manual

ManualsBrandsShenzhen Baoan Hantong Electronics Factory ManualsElectronics2.4 GHz Cordless Phone
12345678910
5
Minutes
Seconds or Channel (Press the SCAN
button to display the channel).
0 0 1 0
CALLS
TALKING. . .
B. Cordless Telephone Operation
B.1 Preparing for Use
Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will
require recharging of the BATTERY PACK more often.
1. Place the HANDSET on the BASE UNIT for 12 hours.
2. After 12 hours, remove the HANDSET from the BASE UNIT.
3. Raise or reposition the BASE UNIT ANTENNA for the best reception.
Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do
so will require more frequent charging of the BATTERY PACK. See page 28 for more information on the
BATTERY PACK.
NOTE:
Depending on the frequency of use, once the HANDSET is fully charged, it remains functional for approximately
4 hours of continuous use and approximately 5 days when the HANDSET is off the BASE UNIT in STANDBY
mode.
B.2 Receiving Calls
1. When the phone rings, lift the HANDSET and press the TALK button. The HANDSET LCD Screen will
display “TALK” and the Call Timer will start to count. The BASE UNIT IN USE LED indicator will light up.
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the HANDSET on the BASE UNIT. When
the HANDSET is placed in the BASE UNIT, all the segment in the LCD Screen will pop-up for 1 second.
NOTE: The Call Timer will start to count once you press the TALK button.
B.3 Placing Calls
1. Press the TALK button, the LCD Screen will show “CONNECTING” for 2 seconds and then display
“TALK” and the Call Timer starts to count. The BASE UNIT IN USE LED indicator will light.
2. Listen for a dial tone.
3. Dial the phone number.
4. When you have finished your call, press the TALK button again or place the HANDSET on the BASE
UNIT.
OR
1. Dial the phone number.
2. The LCD Screen shows “DIAL?” and the dialed number.
3. Press the “TALK” button and the unit will dial the number. The BASE UNIT IN USE LED indicator will light up.
3. When you have finished with your call, press the TALK button again or place the HANDSET on the BASE
UNIT. When the HANDSET is placed in the BASE UNIT, all the segment in the LCD Screen will pop-up for
1 second.
Call Timer Display