User's Manual

Page 2 of 26
Appliance coupler
or separable plug of is used as isolation means to
isolate the equipment from mains supply.
Accessory equipment connected to the analog and digital interfaces
must be certified according to the respective IEC/EN standards
(e.g.IEC/EN950 for data processing equipment and IEC/EN 60601-1 for
medical equipment).
Furthermore all configurations shall comply with the valid version of
the System standard IEC/EN 60601-1-1.Everybody who connects
additional equipment to the signal input connector or signal output
connector
Configures a medical system, and therefore responsible that the system
Complies with the requirements of the valid version of the system
standard IEC/EN 60601-1-1. If in doubt, consult our technical service
department or your local distributor.
Regular maintenance and calibration are recommended
Please note that liquid crystal displays such as the HL1916S SERIAL
do not have a failure rate of zero and image parameters may change over
time (e.g. luminance or discoloration). Please ensure that all
measures are taken to prevent injuries or incorrect diagnoses. Regular
maintenance and calibration are recommended.
Correct and safe operation of the flat panel displays is dependent on
proper transport, storage, installation and assembly, as well as
careful operation and maintenance. The units must only be used for
applications for which monitors are normally used. The information in
the Section "Technical data" must be observed exactly.
For the sake of safety, the following precautions must be observed:
Only use a perfect power supply cable
A damaged power supply cable may result in a fire or electric shock.
When disconnecting the power supply cable, always do so by holding the
plug.
Only use the same type of fuse
T2A/250V
Do not insert any objects into the housing
Objects inserted into the housing may result in damage to the unit or
personal injury.