Use Instructions

ManualsBrandsShenzhen Belter Health Measurement and Analysis Technology ManualsElectronicsSmart Scale

Before Using Scale

1. Remove all packaging materials.

2. Remove the isolator tab from the battery compartment – without opening the battery cover at the bottom of the scale, gently pull out the isolator

tab. (In case the tab cannot be pulled out, remove the screw from the battery cover and remove the cover. Gently pull out the isolator tab. Ensure the

battery is installed correctly. Replace the battery cover and tighten the screw again.)

3. For best accuracy, place scale on tile or hardwood oor, rather than uneven, exible, or soft ooring (such as carpet).

SPECIFICATIONS

⚫ Equipped with a high-precision “Strain-Gauge” sensor

⚫ Product Size:365X315mm

⚫ LCD size:90X40mm

⚫ Capacity 250kg (550lbs)

⚫ Division 100g/0.2lb

⚫ Tap-on start

⚫ Automatic zero reset

⚫ Overload indicator

⚫ Automatic switch off

a. Startup shows 0.0, if the user has no operation, the scale will automatically shut down after about 15S.

b. After the weighing weight is locked, if the user does not get off the scale, the body will automatically shut down after about 10S.

c. After the weighing weight is locked, if the user comes down from the scale, the body will automatically shut down after about 10S.

⚫ LCD display

Battery Replacement

If battery is low and needs to be replaced, “Lo” will appear on screen. Please loosen the screw and remove with the battery cover. Replace the old

battery with three new AAA batteries. Clean the batteries contacts and also those of the device prior to battery installation. Ensure the batteries are

installed correctly with regard to polarity, then replace the batteries cover and tighten the screw again. Remove batteries from the

scale if it will not be used for an extended period of time. Remove used batteries promptly. Properly dispose of the old battery.

Do not attempt to open the scale or to remove any components. Servicing should be done by qualied technicians only.

Switch Unit

Press the button on the back to switch. Lb or kg is available.

INSTRUCTIONS FOR USE

Connectivity status indicator

lb unit

kg unit

Summary of content (3 pages)

PAGE 1
INSTRUCTIONS FOR USE Before Using Scale 1. Remove all packaging materials. 2. Remove the isolator tab from the battery compartment – without opening the battery cover at the bottom of the scale, gently pull out the isolator tab. (In case the tab cannot be pulled out, remove the screw from the battery cover and remove the cover. Gently pull out the isolator tab. Ensure the battery is installed correctly. Replace the battery cover and tighten the screw again.) 3.
PAGE 2
Helpful Hints Bariatric scale is a precise measuring instrument that is most accurate when weighing a stationary object. To ensure the most accurate readings always try to stand on the same area of the scale platform and do not move. Should the weight on the scale exceed the scale’s capacity, you may see an error message ”Err.” Electronic sensors are sensitive. Be careful not to drop or jar the scale. Place it gently onto oor surface, and store where it will be protected from impact.
PAGE 3
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.