User Instructions
Table Of Contents
- 1、Safety Precautions
- 2、Features
- 3、Body temperature and measurement principle
- 4、Product scope/structure composition
- 5、Instructions
- 6.Replacement battery
- 7、Cleaning and maintenance
- 8、Abnormal message
- 9、Product specification
- 10、Fault analysis and troubleshooting
- 11、Calibration mode conversion method
- 12、Warranty commitment
- 13、Electromagnetic compatibility statement
6
1.
The clinical accuracy or clinical deviation of the infrared forehead
thermometer has been clinically verified, and its safety and effectiveness
are in compliance with relevant national regulations. The claimed
performance verification m
ethod of the product can be obtained by
contacting the company's customer service department.
2.
If stored or used outside the temperature and humidity range specified
by the manufacturer, the product may not reach the claimed performance
(use environment: temperature: 10 ℃~40 ℃ relative humidity: ≤
85%
atmospheric pressure: 70.0kPa ~
106.0kPa; storage environment :
Temperature: -20 ℃~+55 ℃ , relative humidity: ≤
93%, atmospheric
pressure: 70.0kPa~106.0kPa).
3. At the end of the service life of the product, there may be c
onditions
that cannot be measured normally. Disposal of electronic medical products
after being discarded may cause environmental pollution. Please dispose
of the waste and residue at the end of the service life of the product
in accordance with local laws and regulations.
4. This product is only suitable for temperature measurement of the forehead
of adults and children, not suitable for temperature measurement of other
parts of adults and children.
5. If you find any problems, you should contact the seller, and
you cannot
repair the product yourself. Note: If the original parts are replaced with
parts not provided by the manufacturer, it may cause measurement errors.
6.
After the infrared forehead thermometer is turned on, it will
automatically self-test. After the automatic self-test, the full-
display
interface will appear and enter the state to be tested; if the normal
automatic self-
test cannot be performed, please do not continue to
measure.