Wiring Diagram

HD05R Remote Control Applications
The button “Test (2s)” is for testing purpose after
commissioning.Pressing this button, the sensor goes to
test mode (hold time is only 2s ).
Detection Rarea
Daylight Threshold
Stand-by dimming level
Definition of the ambient brightness; only when the
ambient brightness is lower than the preset specific lux
amount, the sensor will work; when it's preset as
"disable", the sensor works everytime it detects motion
regardless of the ambient lux level.
-
+
Increase or decrease the parameters.
Test (2s)
Scene
WM/PIR
Hold time
Stand-by period
Press “Reset” button, products with DIP switch will be
controlled by DIP switches; otherwise all the setting will
be just initial, that is 100% detection range,hold time
5S, no stand-by time and daylight threshold disabled.
The period of light keeping low output before it gets
completely off. When it's preset as --, the light always
keep at low output even no movement in the
detection area.
Turn on or turn off the remote control.
ON/OFF
Start
Memory
Apply
Press the button before choosing the parameters.
Press the button after choosing all the parameters to
save them.
Press the button to deliver the saved settings to the
other sensors directly.
Press the button to change the output power from 0% to
100%, it changes 5% every press.
Power %
Change from the microwave sensor function to PIR
sensor function, and the other around.
The area in which movement will trigger the sensor, 100%
detection area also means strong sensitivity.
The period of light keeping 100% brightness after
moving objects leave the detection area.
The definition of low output during the standby period.
Attention
Haisen Technology | 04
Shenzhen Haisen Technology Co., Ltd., Tel: [phone] 丨Fax: [phone]丨Email: [e-mail] 丨www.haisensz.com
1. Please read the instructions carefully before using this product and keep it well
for all users to read at any time.
2. The sensor should be installed by qualified electrician and ensure power is off
before the installation.
3. We reserve the right to modify any incorrect text, image and necessary technical
parameters.
4. Any unauthorized modification is forbidden, otherwise all guarantees will be
immediately invalid.
1. Microwave sensor can be installed in any lamp except the one with full metal shell.
2. The detected surface cannot be shielded by metal objects.
3. Make sure the microwave module is completely exposed outside.
4. The detection surface of the sensor module shall be installed facing the detection area.
5. Should be kept away from the driver to avoid interference generation and lamp flashing.
6. Wiring must be strictly in accordance with the wiring diagram to avoid short circuit.
Installation precautions
1. Suitable for indoor installation to avoid false triggering due to external factors such as rain, wind or
tree swing.
2. Shall not be installed in the place with all four metal shelters and small space (such as
galvanized-iron roof ).
3. Shall note be mounted installation, so as to avoid false trigger caused by the lamp itself shaking.
4. Shall not be installed next to large operating machines such as ventilator/ceiling fan to avoid false
triggering caused by machine vibration.
Application Environment
1.Microwave can penetrate walls or glass thinner than 20cm and attenuate if thicker than 20cm.
2. The driver voltage shall be stable and float within 10%.
3. Detection area will be affected by speed of motion, mounting height and movement volume.
4. Conduct test on sunny days without the lampshade which will affect the tested lux value.
User Notes