User's Manual

5
- If the LED 4 blinking < 100%)
- If all LEDs remain solid, the unit is fully charged.
6. Disconnect the USB cable when it is done.
D. Use Power Bank Function (Output DC 5V 1A max.)
Before use the power bank function, make sure that the Speaker’s
internal battery is full charged. Or, we recommended, it has enough
energy, about 51 ~ 75% or more, for charge the external device.
a. To check the battery remaining energy level:
1. Press once the “ (14)” button, the “Battery Indicators (5)” will
light for 30 seconds to show the battery energy levels.
2. The “Battery Indicators (5)” will illumines as follow methods;
- If no LEDs light = less than 5%
- If the LED 1 is light on = 5-25%
- If the LED 1 & 2 are light on = 26-50%
- If the LED 1, 2 & 3 are light on = 51-75%
- If the LED 1, 2, 3 & 4 are light on = 76-100%
b. To charge your mobile device:
1. Open the “Silicon Cover (1)”, connect Speaker’s “USB Type-A Socket
(8)”, via the included USB cable, to USB micro port on your mobile;
2. The Speaker’s charge output function should turn on automatically. If
not, press the “ (14)” button to begin charging.
• When you mobile device is charged, for about 30 seconds, the charge
output will shut off automatically.
• Disconnect the USB cable when charge finished.
Important: Do not use excessive force when plugging the cable into the
electronic device.
E. Use Wireless Speaker
a. Power On:
1. Press and hold the “ (9)” button to turn on the Speaker;
2. A series of tones will sound from speaker and the “Mode Indicator
(13)” will rapidly flash blue in seconds from blinks, the Speaker is in
pairing mode;
b. Pairing:
1. In pairing mode, then activate the wireless function in your mobile
device (such as Mobile Phone or Personal Computer), the Speaker
will enter to searching/pairing mode automatically, if not, tap the
relate selection to manually enter to searching mode. (refer to your
mobile device’s manual when necessary)
2. Your mobile device should show “BTS11” in Bluetooth Devices list,
and then select it for pairing. Waiting for some seconds and you will
see connected message as shown on your mobile device. (For some