User's Manual

REV：A0 BD-8408G User manual Page

Shenzhen

Bondidea

Technology CO., Ltd

3．

Then it will come out the picture as attached, you can use the mouse after that.

Attention

1．To reach the optimal distance, please insert the receiver 20cm beyond screen and other external device

2. It can prolong the batteries life if you use the mouse on the white surface.

3. Auto-sleeping and power-saving function, it will be auto-sleeping without operation within a long time,

press any key or scroll wheel to activate it.

4. Optical mouse might not work smoothly on some special surface. Such as smooth, glass, dark black,

reflecting and 3D mouse pads surface.

5. Please turn off the power if you ‘re in travelling or you’ll not use it for a long time.

6. When mouse work on metallic surface, the best way is to place a mouse pad under mouse or lay the receiver

horizontally to achive the optimal receiveing effect.

Note:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.