Quick Start Guide

ManualsBrandsShenzhen Cannice Technology ManualsAudio EquipmentBluetooth Headset

Bluetooth Headset

Quick Start Guide

Let's Get Started! On/O & Pairing

Get to Know Your Wireless Earbuds

Charge Your Earphones Carlcare provides service

Take a Clear Phone Call

Enjoy Your Music

1. Earphones x1 pair

2. Charging case x1

3. Eartips x3 pairs, M size installed

4. Micro-USB charging cable x1

5. Quick Start Guide

What’s in the Box?

Check to make sure you

have everything below

0302

1 2

3 4 5

1) Model : A801-12

2) Speaker Diameter : 5.8mm

3) Speaker Impedance : 32Ω±15%

4) Sensitivity MEMS Mic : -38dB

5) Speaker Driver Rating Power: 2mW

6) Charging Cable : 23cm

7) 12 hours of total playtime (with charging case)

8) IPX5 waterproof rating applies to the

earphones, not to the charging case.

Take them out

Power On

automatically &

connect to last paired

device

Android users can further increase volume

by pressing right side earphone two times

even if your device is at maximum volume.

Drop them back and

close the charging case,

Power O

automatically &

disconnect to paired

device

x1 Press Each Side

Play / Pause

x3 Press Each Side

Siri / Google Assistant

Press & Hold

Previous Track

x2 Press

Decrease Volume

x2 Press

Increase Volume

x2 Press

Decrease Volume

x2 Press

Increase Volume

Press & Hold Each Side

Reject Incoming Call

x1 Press Each Side

Answer

x1 Press Each Side

Hangup

Earphones charging

Case charging

About 2.5 hours

5V 0.5A

For the first time use,

open the charging case

cover, earphones will go

to pairing mode automati-

cally, connect your device

by searching for

"Keenpuds2"

If you want to pair with another device, please turn

Bluetooth o on your last paired device if it is nearby,

then open the charging case cover for pairing.

Press & Hold Each Side

for Power On/O (If you are

carrying the earphones

without charging case)

Press & Hold

Next Track

WARRANTY CERTIFICATE

Warning: Changes or modifications to this unit not expressly approved

by the party responsible for compliance could void the user’s authority to

operate the equipment.

NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

380±2mm

95±1mm

108±1mm

When the charging case is fully charged,

3 LED lights will be on.

L earphone charging : Left side LED light is blinking white

R earphone charging : Right side LED light is blinking white

L or R earphone fully charged : The white blinking LED light

will be o