User Manual

13

Changing Remote Control Battery:
Using a Phillips-Head eyeglass screwdriver remove the 3 screws from the back of the RC. Lift the back panel off
from one of the sides with 2 screw holes. Do not lift from the corner that did not have a screw. Firmly pull up
on the side of the battery that is toward the middle of the RC until it pops out. Replace with a CR2032M 3V
lithium battery only. They are easy to find at most superstores and electronics stores. Insert battery under metal
clip and push the battery down and toward the metal clip until it pops into place in the plastic holder. Place the
RC back cover into position by inserting the corner without a screw first. Insert the screws and twist them only
until they stop turning. There is no need to over tighten. It won’t make your show any better.
Restore factory settings