User's Guide

Channel Scan
Your radio can automatically scan channels.
To scan channels:
1. Press and release the Scan button until the Scan icon and the
channel numbers appear on the display.
2. Press and hold the Scan button to begin scanning channels.
The radio ignores specific privacy codes while scanning channels.
The Scan icon will continue to be displayed when scan is on. Your
radio will continue to scan all channels and stop if an incoming
transmission is detected. Your radio will remain on that channel
for 10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the PTT button to communicate on that channel.
Your radio will remain on that channel and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
c. Press and hold the Scan button to return to Standby.
Scan Channels
Privacy Code Scan
Your radio can automatically scan the Privacy Codes (either
CTCSS 01 through 38 or DCS 01 through 83) within one channel.
Only one set of privacy codes (CTCSS or DCS) can be scanned
at a time.
To scan privacy codes:
1. While in Standby mode, press and release the Scan button
twice (CTCSS) or three times (DCS) until the CTCSS or DCS
icon and numbers are flashing.
2. Press and hold the Scan button to begin scanning privacy
codes within the selected channel.
The Scan icon will continue to be displayed when privacy code
scan is on. Your radio will continue to scan privacy codes and
stop as an incoming transmission is detected. Your radio will
remain on that channel/privacy code for 10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following: