User's Manual
Table Of Contents
- Summary
- Applications
- Hardware Description
- Specifications
- Start to use
- Function details
- Changing password
- Authorization
- Single tracking
- Continuous interval tracking
- Smart angle updating
- GPS drift suppression
- Exact street address
- Location based service (LBS) / Cell-ID tracking
- Auto answer
- Forwarding incoming SMS messages
- SIM Card Balance Enquiry
- ACC ON/OFF Alert
- Remote immobilizing
- Fuel sensor calibrating
- Configure times of alarm SMS
- Alarms
- Remote control function (For B model)
- Arming
- Silent Arming
- Disarming
- Alarm function in arming state
- Sleep
- Check Status
- Check IMEI
- Local time setting
- Reset Hardware
- GPRS configuration for live real-time tracking
- Activate Fuel value in GPRS data
- Configure SMS management center number
- Configure heartbeat package interval
- Initialization
- Cautions
- Troubleshooting
27
Note: The first latitude & longitude is coordinate of the top left corner of the
Geo-fence, and the second latitude & longitude is the coordinate of the
bottom right corner.
To configure the Geo-fence the tracker must fix to satellites and be
stationery for about 3-10 minutes.
6.16.6 Movement alarm
The movement feature will create a circle area with a set radius (200 meters by
default). When the tracker moves out of this area, SMS notification
“move!+latitude & longtitude” will be sent to the authorized numbers.
SMS command to activate: move+password+space+radius value
Tracker response: move ok!
Example: move123456 0200
SMS command to deactivate: nomove+password
Tracker response: nomove ok
Example: nomove123456
Note: The unit of the radius value is meter, and the value must be 4 digits and
maximum 9999 meters.
To configure the movement alarm, the tracker must fix to satellites and be
stationery for about 3-10 minutes.
6.16.7 Over speed alarm
The tracker can be configured to send an alert “speed+xxx!+latitude & longitude”
to authorized numbers when a certain speed in exceeded. In SMS mode, tracker
only sends one alert in 3 minutes, and siren beep for one second for each trigger.
SMS command to activate: speed+password+space+speed value
Tracker response: speed ok!
Example: speed123456 080
SMS command to deactivate: nospeed+password
Tracker response: nospeed ok
Example: nospeed123456
Note: The recommended speed should not be less than 30km/h. If the speed is
set lower than this you may get a false alarm due to GPS inaccuracy.