User's Manual

less than 20KM/H”, and stop the car when the speed is less than 20KM/H.
6.20.3 Resume the Oil and Power System
Send “resume+password" to tracker, it will reply "Resume engine succeed", it means
the oil supply is resumed .
6.21 Calibration of fuel sensor
6.21.1 Due to the different height of fuel tank and fuel level sensor specifications,
tracker need to set an appropriate zero value and full range value to detect the precise
fuel percentage.
6.21.2 Zero calibration: Send “ oilzero+password “ to tracker when the fuel tank is
empty , tracker will adjust to zero and reply “ oilzero ok!” . The fuel value is 0%.
6.21.3 Full calibration: Send “oilfull+password “ to tracker when the fuel tank is full ,
then tracker will adjust to full range and reply “ oilfull ok! “ . The fuel value is 100%.
6.22 Function of Remote Controller (Option, for model B ONLY)
Button Function Descriptions
ARM Press for 0.5 second, the siren will beep one time.
DISARM Press for 0.5 second, the siren will beep two times.
ARM &
Silent
mode
Press for 0.5 second when it is in disarm state, the siren will
beep one times. No voice from siren when alarm triggered and
quit from silent mode automatically when disarm.
SOS Press for 3 seconds, Tracker will send SOS alert to authorized phone
numbers without voice.
Deterrence/
car
search
Press for 0.5 second when it is in arm state, siren will beep 10
seconds, press disarm button to quit.
6.23 Arm
6.23.1 Set up arm by SMS
Send SMS command “arm+password” to the tracker device in the vehicle. It will reply
“Tracker is activated” in both armed and disarmed state, and the SMS command will
make the tracker device enter into armed state if the unit currently disarmed.
User must stop the engine, (that is ACC is lower voltage).Sending SMS
“arm+password” when close the door and left. You will set up arm status fail if the
engine is turned on (the ACC is high voltage), it will reply “set up fail! pls turn off
ACC”