User's Manual

Table Of Contents

command in the transmitter. The prompt voice is long Di...Di and vibration, and the

LED flashing. It would enter into the standby status after the acousto-optic vibration

Ended.

6、 When the queue number prompt function open, it would send the queue

number message when sending the heart beat protocol data. When the queue number

decreased, it would prompt by showing current queue number and the pager ID, Long

Di....Di and vibration, LED light would flash twice. It would enter into the standby

status after the acousto-optic vibration prompt.

7、Swing show function.

In order to save the power, the coaster pager would enter into the low consumption

standby status after 10 s without touch. When the customer want to see the queue

number or the pager ID, just by swing silently the Nixie tube would be light

automatically to show the prompt message 10s then enter into the low power

consumption status.

8、In the side of the pager, there's a 3 digits Nixie tube display. It would show its

ID number in the fetch dish mode. In the Queue Mode, it would show the queue

number. Such as : n-2, it means there're two persons before are waiting. The Max

queue number is 9. Over 9 persons it would show "Full". The NiXie Tube adopts

dynamic scroll mode, the Pager ID number and the queue number switch showing

each 3S.

10、Support the cross the border prompt,. The pager would warm when the

pager doesn't receive the heart beat data after the setup interval, to prompt the

customer return within the signal coverage. If the customer won't return back, the

warning would ring all the time. The overtime interval could be modified through the

PC software.

11、Wireless Distance testing function. When the transmitter enter into the

testing status, it would send out one testing command each 10s, the pager would DiDi

prompt when receive the message. This function used for testing the distance during

installation.

12、Low Power inspecting function. When the single-chip detect the battery is

too low, it would prompt the user by the beeper warning from high to low volume,