User's Manual

system would position the chosen message automatically, and pitch on, at this time you could
Press the SEND key to send. If in the fetching the dish mode, if inputting the SN, it
would search according to it, if typing # plus order No. It would search according to the order
#. Such as to search the order 1234, just input#1234，if input #125, then it would turn to red
which means the wrong typing.
2：use the upper key to move the cursor to the middle message area, the message
would be inverse. It could modify the SN through the Up & Dn keys, the
corresponding SN would be displayed in the SN area. By Pressing ESC, the cursor
would returned back to the SN inputting interface, at the same time the SN area would
be cleared.
If the SN inputting wrong, it would display X in the SN area.
Remark：in paging the customer interface, could input the edited message in the
message edit area, but it won't as the sending content. The sending content has been
fixed in the system.
2、Send the cancel command
The SN of the coaster pager small icon would turn green after paging finished. If
you want to stop this paging, use the cursor choose this message, then click on
"Confirm" , then it would bounce up a dialogue box to prompt: whether you confirm
to cancel. Press "Confirm" to cancel.
3、Group calling
Put the cursor in the SN area, input "0", then press "SEND" key, at this time the
screen would bounce up a dialogue to confirm whether send the Group Calling
command. This Group Calling means all of the coaster pagers, click ENT to send out.
The times of clicking ENT, means the sending out times. It would exit till ESC was
clicked.
4.1.2 Staff Single Paging interface
Staff Calling Interface picture4.2， Sn(Serial Number)， Num(Number)，
Note(Remark).
13