User's Manual

Monitor/ Call Cancel
Press the side button set as “Monitor” to turn off CTCSS, DCS, 5-Tone,2-Tone and MDC and to
hear the signals that cannot be heard when in normal work. Press again the Monitor key to return
to normal work.
When in selective call state, press this key to exit selective call.
Squelch Momentary/Call Cancel
Press the button set as “Squelch Momentary” to turn on the squelch; release it to exit.
When in selective call state, press this key to exit selective call
Squelch Off/ Call Cancel
Press the button set as “Squelch off” to turn on the squelch; press it again to exit.
When in selective call state, press this key to exit selective call
Key Lock
Press the button set as “Key Lock” to lock or unlock the following function keys: Channel knob,
Annunciation Selection , Talk Around, Lone Worker, Scan, Noise Channel Delete, Call Forward,
H/M/L Power Switch, Squelch Adjust, Normal Record/Record Stop,Protected Record/Record Stop,
Record Delete, Surveillance , CTCSS Scan etc.
Battery Power Check
Press the button set as “Battery Power Check” to hear the current power level. If you hear “Very
low battery”, you need to recharge the radio as soon as possible.
Surveillance
Press this key to disable or enable Surveillance function.
When this function is enabled, the beep is not heard and the LED does not light when a signal is
received, or a key is pressed.
CTCSS SCAN/(Forever) Save Channel
Press this key to enter the CTCSS SCAN function. CTCSS Scan can find a RF channel with
its CTCSS.
If the channel was the wanted channel, the use can Press “CTCSS SCAN/SAVE CH” or
“CTCSS SCAN/Forever SAVE CH” to save the landon frequency to the current channel
both in RX & TX frequency, and also the CTCSS. The difference between the above two
keys is that “Forever SAVE CH” means you can not enter CTCSS SCAN on the current
channel again, whereas “SAVE CH” can re-enter.
■ VOX (Voice Operated Transmission)