User's Manual

User Manual for All-in-One Health Monitor
Page XXI/69
Step 3: Take a new test strip, insert it into the test slop of the device, then the device will automatically turn on , and
display the current temperature first then show the blood icon.
Step 4: Refer to the following operations for lancing device and blood lancet. When the blood drop icon appears, apply
the blood drop to the front edge of the test strip, put the blood sample on the injecting hole.(Note: before making
measurement, make sure the blood is full of the injecting hole.).
Step 5: The Glucose Monitoring System and the Monitor will simultaneous display the test result after about 5 seconds,
the unit is mmol/L, as shown in figure 2.7A and 3.1B.
Step 6: Remove the used strips by hand or by pushing the ejector and the device will turn off and display "OFF" on the
screen.