User's Manual

User Manual for Fingertip Oximeter
10
3.4 External SpO
2
Probe Connection
1. Connect the external SpO
2
probe to SpO
2
sensor
connector in the following way. Make sure the side
with “Arrow” faces upwards.
Figure 6 Probe Connection
Note: when the external SpO
2
probe is connected well,
the built-in finger clip sensor will be disabled. The
measurement is detected from the external SpO
2
probe.
2. The finger should be put in SpO
2
probe properly and
correctly.
3. The oximeter will power on automatically 2 seconds
later, then display software version number.
4. Other operation is similar to chapter 3.1 directly
measurement.