Instruction Manual

Assembly Collar
Please refer to the picture to wear the collar on the dog's neck.
Adjust the length of the collar.
Turn on the Receiver Collar
 Press the On/Off Button the Green LED light comes on.
 In normal mode, the Green LED will flash every 2 seconds, indicating the Receiver
Collar is on and ready to receive a signal from the Remote.
Turn off the Receiver Collar
Press On/Off Button, then press and hold On/Off Button again until the Red LED light
flashes 3 times to shut off (This takes approximately 3 seconds).
Release the On/Off Button.
NOTE:
To extend the life of the batteries, please turn the Receiver Collar off when it is not in use.
Function Test
We recommend you experience firsthand how the different levels feel on yourself and
always begin at the lowest level, and increase the levels up to your personal comfort
levels.
1. Hold your remote approximately 2 ft. from the training collar. Press the Vibration
Button continuously for 1 to 2 seconds. You should feel continuous vibration.
2. Press to decrease levels. Starting at level 1,press the Shock Button.
3. Increase the level until the sensation begins to feel uncomfortable.
NOTE: Continuous stimulation will transmit for no more than 10 continuous seconds. To
reactivate, release and repress the button.
Tone: sends a tone with non-adjustable level to the Receiver Collar.
Vibration: sends a vibration with non-adjustable level to the Receiver Collar.