Instruction Manual

Shock: sends 1-16 adjustable levels of static stimulation to the Receiver Collar.
Slide up, control dog 1, slide down, control dog 2.
Short press to turn on, long press to turn off.
Press to increase the Shock Level
Press to decrease the Shock Level.
Note:
The Shock Level can be adjusted from 1 to 16 levels , please adjust it properly as per your
dog’s reaction.
It is not recommended to press and hold the Vibration/Shock Button too long to avoid
physical or psychological hurt to the dog.
How to Use the Test Lamp
Shock Function Test
1. Turn on the Receiver Collar.
2. Hold the Test Lamp contacts against the Contact Points (or Conductive Silicone).
3. Press the Shock Button and the Test Lamp will be lighted. It will be lighter accordingly
with the Shock Level increasing.
As a Spanner
Use the Test Lamp to tighten or loosen the Contact Points when prepare the Receiver
Collar.
Pair the Remote and the Receiver Collar
1. Use the switch on the Remote to select Dog 1 .
2. With the Remote turned on and the Receiver Collar turned off, press and hold the
ON/OFF Button on the Receiver Collar for 4-5 seconds.
3. The Red & Green LED will blink for about 10 seconds indicating that it is ready for
pairing.
4. Press and hold Tone Button and Vibration Button at the same time for 2-3 seconds,
the Green Led on the Receiver Collar will blink for 5 times indicating successful pairing.