Installation Instructions

Sport information:
show steps,
calories,
distance
Heart rate:
measure
automaticly for
30's to check
heart rate
Sleep monitor:
shows sleeping
time and quality of
last night
Message reminder:
long press to enter
to browse QQ,
WECHAT,SMS
message
Anti-lost:
long press the
interfaceto ring
your phone
ECG function:
long press to enter and
put one of your hand on
the side steel button to
test and last 30's, check
on your phone app
Blood pressure:
measure blood pressure
automaticlly when enter
this interface and still for
30'syour phone app
Multi sport mode:
long press to enter multi
sport mode, press again
to start any sport mode
Stop watch:
long press for 5's to
start stop watch and
long press again to quit
Power off:
long press for 3's will
shows YES or NO,
choose YES and long
press to power off
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for
help.
FCC Radiation Exposure Statement：
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other antenna
or transmitter.
FCC Caution: