User's Manual

Features
1. Optimal Wireless Sound from Your Bluetooth Device
2. Share your music with anyone, wirelessly from virtually anywhere in the room.
3. Volume control and the Bluetooth connect buttons are conveniently placed for easy access.
4. Integrated AUX-IN allows you to connect other audio devices
5. Compact and simplistic curve design to save space
Specifications
Total RMS Power : 20 Watts
Total Peak Power : 40Watts at <10% THD
System THD : Better than 0.05% THD before clipping
Signal to noise ratio : >80dB
Frequency response : 30Hz-20kHz
Driver Size : 2x2.8 inch
Speaker dimensions : 300L x 150D x 140H(mm)
Operating Range: Up to 10 meters(measured in open space walls and structures may affect range
of device).
Bluetooth Technology: version 2.1+EDR A2DP
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.