® Remote: TC01-C1 Reciver: TC01-R1 ON OFF Model: TC01 If any quality problems or confusion, feel free to contact us via +1(833)-220-1900 support@dogcareglobal.
1 120Minutes Complete charging in 2 hours.Offer only one wire in the package. 2 2s ON OFF Turn on the receiver : Hold the ON/OFF button for 2 seconds and the receiver will beep and vibrate.
ON / OFF To turn the transmitter on. 4 Security Keypad Lock: Toggle it down to unlock.
5 ON OFF Vibrate Command: Press the vibration button briefly and the receiver vibrates once. 6 ON OFF ON OFF Beep Command: Press the beep button briefly and the receiver beep once.
7 HOLD Static Intensity Adjustment: Press and hold the LEVEL button while rotating the remote control switch to adjust the shock intensity. Static Command: Press the static button briefly and the receiver shock once. 8 9 Channel Switching: Able to train 9 dogs at the same time. Press the channel button briefly to select the dog to train.
9 5s ON OFF Pairing: Refer to “Page10”for more information. I. Package Content ON OFF Remote Control 1 2 Receiver 3 Collar ® NO OFF Model: TC01 If any quality problems or confusion, feel free to contact us via +1(833)-220-1900 4 USB Cable 5 Lanyard 6 support@dogcareglobal.
Receiver ON/OFF Static Electrodes ON OFF Sound Speaker including Silicone Caps for electrodes LED Status Light USB Charging Port & Rubber Lid COLLAR STATIC STIMULATION QUICK GUIDE When wearing the collar, it is most suitable if one finger can be insert ed under it. Too tight is not good for your dog, but too loose will dull the static function for the electrodes cannot touch your dog’s skin. Not feelling the SHOCK? Try these solutions.
II.
III. Setting Up 1. Charge the devices respectively for 2-3 hours. Remote Control: Charge the device until the battery icon on the display indicates full bars. Receiver: Charge the device until the red LED turns green. The display on the Remote will indicate full bars as well. If you charge it for a long time. The receiver couldn't hold a charge. 2.
3. When wearing the collar, the tightness is at most fit if one finger can be inserted underneath. 4. The Silicone Caps can dull the static sensation, you should decide weather you need to put them on. The soft caps also protect your dog from direct contact with metal electrodes, which in some cases will cause discomfort. V. Training Modes 1. Vibration Mode: Press Vibrate Button, and the Receiver will vibrate once; hold the button and the vibration persists. NO OFF 2.
VI. Match the Remote Control to the Receiver: *You may skip this step because the set is already paired by factory setting. ON OFF After confirming that the receiver is turned off, hold the ON/OFF button of receiver for 5 seconds until the LED indicator Light on receiver flashes in green. Press and hold Channel Switch / Match Button for 5 secs. The Receiver will vibrate and beep which indicates the matching is completed.
3. Use verbal commands first, and supplement with a corrective stimulus only as needed. Be consistent with your verbal commands, using the same words every time. Work with your pet on one behavior at a time to avoid confusion and frustration. Use as little stimulus 4. as possible and only to reinforce verbal commands when necessary. Do not over correct your dog. 5. For example, use the beeps as warning by pressing Beep Button.
is harsh way to train a dog. Always, the praise could encourage your dog for good behavior. Note: With Anti-Misoperation design, Static function always cut-off after 4 secs, this is a precaution designed to prevent unintentional long-pressed of the button, and potential animal abuse. IX. Troubleshooting 1. Remote/Receiver runs out of power quickly; not charging Make sure the charger and Remote/Receiver is securely connected. Try to use other universal android USB cable to charge. 2.
4. Avoid dropping the devices on hard surface or inflict excessive force on them. 5. Avoid using the devices in environment flooded with corrosive chemical, this may lead to color degrading, deforming, or cracking of exterior of the devices. Maintenance: 1. When not in use, please wipe clean both the Remote and Receiver with mild detergent. Turn off the Remote, lock the keypad, put on the rubber lid on the Receiver’s charging port, and store the set in a cool dry place. 2.
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
® If any quality problems or confusion, feel free to contact us via +1(833)-220-1900 support@dogcareglobal.