User's Manual

ManualsBrandsSHENZHEN ECARE ELECTRONICS ManualsElectronicsRemote Pet Training Collar for Multi-dogs

Table Of Contents

Step

Powering on and off the Remote Transmitter

There is no need to turn off the transmitter. When there is no buttons

being pressed on transmitter, the unit turns off automatically. Press any

button and the transmitter will power back on automatically.

Powering on and off the Collar Receiver

There are two ways to power on and off the Remote Collar Receiver:

Option 1:

Press the ON/OFF button on the receiver to power the unit on or off. When

the receiver is powered on, the indicating light will flash green.

Option 2:

Press and hold the Vibration and Sound Button at the same time for a

few seconds to turn on or off the receiver. Please note, this feature can

only be utilized if the distance between the transmitter and receiver is

less than 100 feet or 30 meters and the transmitter and receiver must

already be paired.

Step 2 – Pairing Collar Receiver to Transmitter

Note: Transmitter and receiver are pre-paired when leaving our

manufacturing facility. In case the pairing is not established or you would

like to repair the units, please follow the instructions below:

1. Power on the Collar Receiver by pressing the ON/OFF button on the

Collar Receiver.

2. Press and hold the ON/OFF button for about 3 seconds until a beep

sounds, and the indicating light will begin flash quickly.

3. Press any button on the transmitter once the Collar Receiver beeps.

When the Remote Transmitter and Collar Receiver are paired successfully

the indicating will stop flashing quickly.

4. If needing to pair a second Collar Receiver, follow the same steps but

first push your Toggle Switch in the other direction.

Step 3 - Test the Training System Functions

The testing methods will help determine whether the training system is

functioning as intended and will also teach you how to operate the system.

Please ensure that the pairing process is complete before attempting to

test the functionality.

Testing the Electronic Pulse Stimulation

Electronic Pulse Stimulation Tester

In your package that you received, you will find a clear almost translucent

plastic piece that has a light bulb/fuse in the middle of it. This is your

Electronic Pulse Stimulation tester. This component DOES NOT attach

to the Collar Receiver by any means and is only for testing the static shock

mode. To test the Electronic Pulse Stimulation, follow these steps:

1. Put the test light over the Electrodes of the Collar Receiver you wish

to test.

2. Ensure the Toggle Switch is in the correct position for the Collar Receiver

you're testing.

3. Adjust the Intensity Dial off of 100.

4. Press the Static Shock Button on your Remote Transmitter.

5. If done correctly, the test bulb should flash orange indicating the

electronic pulse stimulation is operating correctly.

Step

Note: Before first use, charge the Remote Transmitter and Receiver Collar

until completion.

(Figure 3-1)