User's Manual

Wireless Adapter
(1).Network Card Installation
Please follow the following steps to install your new wireless
network card:
1.Insert the USB wireless network card into an empty USB2.0 port
of your computer when computer has power on. Never use force to
insert the card, if you feel it’s stuck, flip the card over and try again;
2.Insert device driver CD into the CDROM drive of your computer,
double click the ‘Setup.exe’ icon and run the ‘Setup.exe’ program;
3.Select ‘I accept the terms of the license agreement’, and then
click ‘Next’;
4.Select the setup type that best suits your needs, ‘Install driver and
Ralink WLAN Utility’ are recommended;
5.Click ‘Next’ , show the ‘Mediatek Configuration Tool’ dialogue, you
can manage this wireless adapter both by “Mediatek Configuration
Tool” and “Microsoft Zero Configuration Tool”;
6. Click ‘Next’, and Show ready to install dialogue;
1
2 3 4 5
3.Choose the wireless access point’s SSID, and double-click it. If
the AP is encrypted, you should follow the prompts to select the
appropriate encryption type and enter a password;
4. After you have connected to the wireless access point
successfully, you can get the detail information of connected
access point, such as status,IP address,speed and so on. Click the
icon ,then the ,you will see the signal quality and signal
strength information.
9 10 11
6 7 8
7.Click ‘Install’, and the installation is in process; 8.Finally, click ‘Finish’ to finish the driver installation;
(2).Connect to Wireless Access Point
1. After installation has finished, it will try to connect to any
unencrypted wireless access point automatically. If you want to
connect a specific wireless access point, or the access point you
wish to connect uses encryption, you have to configure the wireless
network card and input the correct password to get connected to the
wireless access point. Double click to open desktop lower icon
2. Displays the following picture;
Click the icon ; Scan available wireless access point. Scan
results will display in the ‘Network’ zone. If you can’t find the access
point you wish to connect here, click the Refresh button, until
you can find your wireless access point;