Installation Instructions
Table Of Contents
FCC
Caution ：
This
device
complies
with
part
15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
This
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause undesired operation.
Any
Changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could void the user's authority
to op erate
the
equipment.
Note:
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursuant
to
part
15
of
the
FCC
Rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates
uses
and
can
radiate
radio
frequency
energy
and,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following
measures:
-Reorient or
relocate
the
receiving
antenna.
-Increase
the separation
between the
equipment
and receiver.
-Connect
the
equipment
into
an
outlet
on
a
circuit
different
from
that
to
which
the
receiver
is connected.
-Consult
the dealer or
an
experienced radio/TV
technician for help.
The device
has been evaluated to meet
general
RF
exposure
requirement.
The device
can be used in portable
exposure
condition without
restriction.