Product Specs

WiFi AP Module Product Specification

Model Name.: M31

11 Statement



FCC Statement

This device complies with part 15 of the FCC rules.Operation is subject to the following two conditions:

(1) thi

s device may not cause harmful interference

(2)

this device must accept any interference received, including interference that may cause undesired

operation.Changes or modifications not expressly approved by the party responsible for compliance co

uld

void the use

r’s authority to operate the equipmen

NOTE

: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of th

e following measures:

• Reorie

nt or relocate the receiving antenna.

• Increa

se the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dif

ferent from that to which the receiver is connected.

• Consult the deale

r or an experienced radio/TV technician for help important announcement

Important Note:

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for anuncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator and your

body.This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.

Important Note:

In the event that these conditions cannot be met (for example certain laptop configurations or co‐location with

another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used

on the final product. In these circumstances, the OEM integrator will be responsible for re‐evaluating the end

product (including the transmitter) and obtaining a separate FCC authorization.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator and your

body.

This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.