Service manual

www.enc.net.cn/en Tel/Fax:[phone] Run and operation explanation for inverter
31
4 Run and operation explanation for inverter
4.1 Run of inverter
4.1.1 Running order channels
There are 3 kinds of order channel for controlling run action of the inverter
such as run, stop, jog etc.:
0: keypad
Control by key , , on keypad(factory default).
1: Control terminal
Use control terminal FWD, REV, COM to make of double-line control，or
use one terminal of X1～X8 and FWD or REV to make of three-line control.
2: Serial port
Control run and stop of the inverter through upper machine or other device
which can communicate with the inverter.
Choose order channel by setting function code F0.02；and also can choose by
multi-function input terminal(F5.00~F5.07 choose function 29, 30, 31).
4.1.2 Frequency-provision channel
EDS1000 common run mode there are 10 kinds of provision channel:
0: keypad analog potentiometer provision；
1: direct digital frequency provision；
2: terminal UP/DOWN provision(store after power-off or stop)；
3: serial port provision；
4: analog value VCI provision；
5: analog value CCI provision；
6: analog value YCI provision；
7: terminal pulse(PULSE) provision；
8: combination set;
9: terminal UP/DOWN provision(not store after power-off or stop)
4.1.3 Work state
Work state of EDS1000 is classified as waiting state and running state:
waiting state: If there is no running command after the inverter electrified or after
stop command during running state, the inverter enters into waiting state.
running state: the inverter enters into running state after receiving run command.
STOP
RUN
REV
JOG
Please make switching debugging in advance when switch the order channel to check if
it can fulfil system requirement，otherwise have danger of damaging device and injuring
personal.
!