Service manual

www.enc.net.cn/en Tel/Fax:[phone] Function parameter schedule graph
56
Fd.14
Accumulative run time at
previous failure
Accumulative run time of previous
failure
0 *
FF－Password and manufacturer function parameter group
Function
code
Name Setting range
Min.
unit
Factory
default
Modifi
-cation
FF.00 User password 0000－9999 1 0000 ×
FF.01 Manufacturer password 0000－9999 1 0000 ×
FF.02-
FF.0X
Manufacturer’s special parameter ×
C－Supervision function parameter group
Function
code
Name Description
Min.
unit
Factory
default
Modifi
-cation
C-00 Set frequency Current set frequency 0.01HZ
C-01 Output freq. Current output freq. 0.01HZ *
C-02 Output current Virtual value of current output current 0.1A *
C-03 Output voltage Virtual value of current output voltage 1V *
C-04 DC bus-bar voltage Current DC bus-bar voltage 1V *
C-05 Load motor speed
Product of output frequency and load
motor speed emendation factor
1(r/m) *
C-06 Module temperature IGBT heat sink temperature 1℃ *
C-07 Run time Inverter electrification run time 1h *
C-08 accumulative run time Inverter accumulative run time 1h *
C-09 Input terminal status Switch value input terminal status ―― *
C-10 output terminal status Switch value output terminal status ―― *
C-11 Analog input VCI Analog input value of VCI V *
C-12 Analog input YCI Analog input value of YCI V *
C-13 Analog input CCI Analog input value of CCI V *
C-14 Exterior pulse input Exterior pulse input 0.1KHz *
(1) input terminal status corresponding relation is as follows:
(2) output terminal status corresponding relation is as follows:
REV input terminal
FWD input terminal
X1terminal status
X2 terminal status
X3 terminal status
X4 terminal status
X5 terminal status
X6 terminal status
: shows terminal input ineffective
: shows terminal input effective
: shows that terminal has no output
: shows that terminal has output
OC4 out
p
ut terminal
OC3 output terminal
OC1 out
p
ut terminal
OC2 output terminal