User's Manual
12
Face Recognition Temperature Monitor user's manual
Wall punching size chart
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC’s RF radiation exposure limits for general population/uncontrolled
exposure, this device must be installed to provide a separation distance of at least 20cm from
all persons.
WAR
NING:
Any
changes
or
modifications
t
o
this
uni
t
not
expressly
approved
by
the
part
y
respo
nsible for
compliance could void the u
ser’s aut
hority to operate the equipm
ent.
This
device
must
not
be
collocated
or
operating
in
conjunction
with
any
other
antenna
or
transmitter.