User's Manual

This device complies with Industry Canada licence-exempt RSS standard(s).
Operation
is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformémentà la réglementationd'Industrie Canada, le présent émetteur
radiopeutfonctionner avec uneantenne d'un type et d'un gain maximal (ouinf
érieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectriqueàl'intention des autresutilisateurs, il
fautchoisir le type d'antenne et son gain de sorteque la puissance isotroperayonn
ée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaireà l'établissement
d'une communication satisfaisante.
Le présent appareilestconforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitationestautorisé e aux deux
conditionssuivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareildoit accepter tout brouillage radioélectriquesubi,même si le
brouillageest susceptible d'encompromettre le fonctionnement
Maintenance
This Clamp Meter is designed to provide years of dependable service,if the following
care instructions are performed:
1、 KEEP THE METER DRY，If it gets wet,wipe it off.
2、 USE AND STORE THE METER IN NORMAL TEMPERATURES.Temperature
extremes can shorten the life of the electronic parts and distort or melt plastic
parts.
3、 HANDLE THE METER GENTLY AND CAREFULLY.Dropping it can damage the
electronic parts or the case.
4、 KEEP THE METER CLEAN.Wipe the case occasionally with a damp cloth.
DO NOT use chemicals,cleaning solvents,or detergents.
5、 USE ONLY FRESH BATTERIES OF THE RECOMMFNDED SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6、 IF THE METER IS BE STORED FOR A LONG PERIOD OF TIME,the battery should
be removed to prevent damage to the unit.
4
This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general population (uncontrolled exposure).
This device must not be collocated or operating in conjunction with any other antenna or transmitter.