User's Manual

between
o
F or
o
C. and in current position to select between AC or DC current
measurements.
To press and hold the mode key to turn the system on, the auto power off function will be
cancelled.
Press the Mode/Bluetooth until the Bluetooth turns on or off.
PEAK/ INRUSH
NOTE: Only ACV functions can do the peak value measurement.
PEAK Key is the peak value measurement key that acts with trigger.
NOTE: Only ACA functions can do the INRUSH value measurement.
1. Close motor and then install Jaw or Flexible coil
2. Press the INRUSH button , “----”will appear in the display.
3. Open motor and then read the value on the display.
Data Hold/Backlight
To freeze the LCD reading, press the HOLD button. While data hold is active, the HOLD
icon appears on the LCD. Press the HOLD button again to return to normal operation.
The LCD is equipped with backlighting for easier viewing, especially in dimly lit areas.
Press the backlight button to turn the backlight on. Press again to turn the backlight off.
Note :
that the meter does have an auto power off feature as described below.
Relative
1. Press the REL button to zero the display. “ REL ” will appear in the displ
ay. The displayed reading is now the actual value less the stored “zero” valu
e.
2. Press the REL button to view the stored value. “ REL ” will flash in the display.
3. To exit this mode, press and Hold the REL button until “ REL ” is no longer in the
display.
MAX/MIN
Press MAX/IN key the maximum and minimum values are measured. This mode is
activated on each measurement except for continuity test, diode test capacitance test,
frequency test and duty cycle test.
This mode is disabled keeping pressed MAX/MIN key or moving the rotary switch.
HZ/%
With rotary switch on HZ/%, Voltage, Current, positions, the Hz% key permits to select
the frequency test ( Hz ) or the duty cycle test(%).
LCD Backlight Button