User's Manual

Relative mode
The relative measurement feature allows you to make measurements relative to a stored reference value. A reference
voltage, current, etc. can be stored and measurements made in comparison to that value. The displayed value is the
difference between the reference value and the measured value.
1. Perform the measurement as described in the operating instructions.
2. Press and Hold the REL button to store the reading in the display and the "REL" indicator will appear on the display.
3. The display will now indicate the difference between the stored value and the measured value.
4. Press and Hold the REL button to exit the relative mode.
PEAK HOLD
The Peak Hold function captures the peak AC voltage or current. The meter can capture negative or positive peaks as
fast as 1 millisecond in duration. Press the PEAK button. “PEAK MAX” will appear in the display, Press the PEAK
key again and the display icon "PEAK MIN" will appear. The meter will update the display each time a higher
positive and nagetive peak occurs. Press and hold the PEAK button for 2 seconds to exit the mode.
DISPLAY BACKLIGHT
Press the HOLD/
key for >2 second to turn the backlight on. The backlight will automatically turn off after 10
seconds.
HOLD
The hold function freezes the reading in the display. Press the HOLD key momentarily to activate or to exit the HOLD
function.
LOW BATTERY INDICATION
When the low battery
+
icon appears in the display, the battery should be replaced.
AUTO POWER OFF
The auto off feature will turn the meter off after 15 minutes. To disable the auto power off feature, hold down the
MODE button and turn the meter on. “APO d” will appear in the display. Turn the meter off and then on again to
re-enable the auto power off feature.