User's Manual

PREPARATION

Installing / Removing the Battery

1. Match the two grooves of the battery pack with the

corresponding guides on the back of the transceiver,

and then push it.

2. Press the battery pack until the release latch on the top

of the transceiver locks. After hearing a “click” sound,

the battery has been locked.

3. To remove the battery pack, slide up the release latch

and remove the pack away from the transceiver.

Installing / Removing the Antenna

■

Installing the Antenna:

Screw the antenna into the connector on the top of

the transceiver by holding the antenna at its base

and turning it clockwise to secure it.

■

Removing the Antenna:

Turn the antenna anticlockwise to remove it.

NOTE: Please turn off the transceiver before removing

the battery.

PREPARATION

Installing / Removing the Belt Clip

■

Installing the Belt Clip:

Place the belt clip to the corresponding grooves on the

back of the transceiver, and then clockwise screw it.

■

Removing the Belt Clip:

Turn anticlockwise the screws to remove the belt

clip.

Installing the Additional Speaker/ Microphone

Unveil the MIC-SP jack cover and then insert the

Speaker/Microphone plug into MIC-SP jack.

NOTE: Using the additional speaker/ microphone

will influence the waterproof performance of the

transceiver.

,.?

DEF

MIC