User's Manual

Basic Operations

Turning the Repeater On/Off

 ON: Turn on the repeater by connecting an AC or a DC power supply to it. During the

power-up process, the Power indicator glows green and the LCD shows animation.

 OFF: Disconnect the AC/DC power supply.

Reading from/Writing to a Repeater

This option instructs the PC to read/write data from/to a repeater through the RJ45

Ethernet connector located at the rear panel of the repeater. The repeater could be

connected to the PC directly or to the PC via router in LAN.

 Connecting Repeater to the PC Directly

PC Repeater

1. Connect the repeater to the PC with a network cable.

2. Check the repeater IP address via menu operation.

3. Set the PC IP address to be in the same network segment as that of the repeater.

4. Click “Connect” at the CPS menu bar and then the Connect to Repeater window

appears.

5. Click “Scan” to search for the repeater to which the PC will connect.

6. Select the IP address and click “OK” to connect the repeater to the PC.

If connection is successful, is displayed at the CPS status bar.

Upon successful connection, you may click “Read” or “Write” at the CPS menu bar to read

from/write to the repeater.

 Connecting the Repeater to the PC via Router in LAN

