User's Manual

Basic Operations
14

RouterPC Repeater
LAN
1. Connect the repeater to the PC via the router in LAN using a network cable.
2. Check the repeater IP address via menu operation.
3. Set the PC IP address to be in the same network segment as that of the repeater.
4. Click “Connect” at the repeater CPS menu bar and then the Connect to Repeater
window appears.
5. Click “Scan” to search for the repeater to which the PC will connect.
6. Select the IP address and click “OK” to connect the repeater to the PC.
If connection is successful, is displayed at the CPS status bar.
Upon successful connection, you may click “Read” or “Write” at the CPS menu bar to read
from/write to the repeater.
Note: Before writing to the repeater, you may revert the PC IP address to its
previous one and set the repeater IP address to be in the same network segment
as that of the PC, to facilitate normal PC operation.
Adjusting the Volume
Press the key to increase the volume or the key to decrease the volume.
Squelch Level
This option can reduce background noise by adjusting the squelch level when the repeater
is receiving signals. You may set the squelch level to Tight, Normal, or Open using the
repeater menu. Tight squelch level can filter weak signals, and allow only strong signals to
be received. If the squelch level is set to Open, the repeater will turn on the speaker and
background noise will be heard.
Follow the procedures below to set the squelch level.