User's Manual

Basic Operations

5. Press the SET key to enter the Menu Reset menu.

6. Use the / key to select Never or a desired menu reset time.

7. Press the SET key to save the settings in the system.

To exit this menu, press the EXIT key.

TX/RX LED

This option decides whether to give any LED alert when the repeater is transmitting and/or

receiving.

You can set the following TX/RX LED related parameters: LED Switch, TX LED, and RX

LED.

 LED Switch: If the On option is selected, TX LED and RX LED light when

the

repeater is transmitting and receiving. If the Off option is selected, Neither TX LED nor

RX LED lights when the repeater is transmitting and receiving.

 TX LED: If the On option is selected, TX LED lights when the repeater is

transmitting. If the Off option is selected, TX LED does not light when the repeater is

transmitting.

 RX LED: If the On option is selected, RX LED lights when the repeater is receiving. If

the Off option is selected, RX LED does not light when the repeater is receiving.

Follow the procedures below to set TX/RX LED related parameters.

Procedure:

1. In the home screen, press the SET key to enter the main menu.

2. Use the / key to select the “Repeater Settings” option.

3. Press the SET key to enter the Repeater Settings menu.

4. Use the / key to select the “LED” option.

5. Press the SET key to enter the LED menu.

6. Use the / key to select any of the TX/RX LED related parameters among

LED Switch, TX LED, and RX LED.

7. Press the SET key to enter the LED submenu.

8. Use the / key to select On or Off.

9. Press the SET key to save the settings in the system.

To exit this menu, press the EXIT key.