Installation Instructions

FCC Statement
This device complies with part 18 of the FCC Rules. Operation is Subject To the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 18 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and candidate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
This device complies with Part 18 of the FCC Rules. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
* Increase the separation between the equipment and any other radio device.
* Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
surrounding the device and 20 cm above the top surface of the device must be
respected.
ISED Statement
This device complies with Industry Canada's license-exempt RSSs. Operation is subject
to the following two conditions:
* This device may not cause interference; and
* This device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
* l'appareil ne doit pas produire de brouillage;
* l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the device and
10 cm above the top surface of the device must be respected.
Cet équipement est conforme Canada limites d'exposition aux radiations dans un
environnement non contr?lé.
au cours de l'opération de l'appareil sur une distance de 10 cm autour de l'appareil
et de 10 cm au - dessus de la surface supérieure de l'appareil doit être respecté.
LED table lamp
LED table lamp
1.5A