Setup Guide

12
Flash (for 2S): Indicates detection of noise
signals, prompting the user that current
location has high level noise. You can either
set dip switch 3, 4 to mid or low sensitivity
level which raised to a higher threshold level
for noise filtering, or you can find another
location for lower noise level.
Steady on (for 2S): Indicates detection of
interference signals. It means there is lightning
like signals around. You should try to find
interference sources like motor, switches for
all kinds electrical appliances, and place the
sensor far away from these interference
sources.
Steady Off : Indicates no triggering of
lighting signal neither noise, nor interference.