Operation Manual

- 8 -
Figure 10: Sensor packa nting diagram
Note
the antenna, there is an arrow icon with ”NORTH” words (Figure 11)representing the direction of north. The
igure 11
Now look at the bubble l bble should be fully inside the red circle. If it is not, wind direction, speed,
tion step, and now
tton and Transmitter LED
old the RESET BUTTON (see Figure 12) to affect a reset: the LED
ge mou
Beside
sensor body has to be adjusted so that the “NORTH” indication is facing to real north direction in your location. A
compass device is recommended to help adjust direction. Permanent wind direction error will be introduced when
the outdoor sensor is not installed in right direction.
F
evel. The bu
and rain readings may not operate correctly or accurately. Adjust the mounting pipe as necessary. If the bubble
is close, but not quite inside the circle, and you cannot adjust the mounting pipe, you may have to experiment
with small wooden or heavy cardboard shims between the sensor package and the top of the mounting pole to
achieve the desired result (this will require loosening the bolts and some experimentation).
Make sure you check, and correct if necessary, the northly orientation as the final installa
tighten the bolts with a wrench.
6. Reset Bu
Using a bent-open paperclip, press and h
turns on while the RESET button is depressed, and you can now let go. The LED should then resume as
normal, flashing approximately once every 48 seconds.
RESET button
LED light
Figure 12