User's Manual

users will find everything and can download new firmware,
Decompress the new firmware( "rar" file) downloaded(but can’t
change the file name).
B. Upgrade Way 1
copy all the files to one Micro SD card.---> insert the Micro SD
card to the Tablet PC(make sure the Tablet PC is turned off before
you insert the card).---->when the SD card is inserted to the
device, pls turn on the device by pressing the power button for
about 10 seconds,--->when you see message on the screen which
remind you the system is being upgraded, the upgrading begins,
you do not need to do anything, the system will upgrade
automatically.---> after 5 to 6 minutes, the system will remind you
to remove the SD card, pls do this.--->the device will turn off
automatically-->when you turn on the device again, the system has
already been upgraded
C. Upgrade way 2
Install upgrade tooling software on computer, connect the tablet
with computer by the usb cable, then upgrade tablet through the
installed upgrade tooling software on the computer.
NOTICE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by Shenzhen Firstview Electronic
Co., Limited may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.