USER MANUAL Heart rat e Armband HW807 English Version v1.
1. Product Introduction Thank you for purchasing our ANT+ & BLE heart rate armband, this product is one of the heart rate monitors of our company, which transmits the real-time heart rate data through BLE or ANT+ to heart rate receiving device, sports and health App, helping you to manage your exercise intensity scientifically. This user manual will help you to use the product better, please keep it for reference.(This product is for sport purposes only and it is not meant to replace any medical advice). 2.
. Basic Parameters Product size: 46.5*36*14.5mm Weight: 20g Power: 90mAh Rechargeable lithium battery Battery life: 16 hours for continuous heart rate monitoring Working temperature: 0℃~40℃ Transmission: ANT+, BLE 4. Function and Operation Turn-on: Press the start-up button, the LED light will flash blue quickly until the heart rate was found. Turn-off: Hold the start-up button, The LED will flash red light and vibrates,then enters the shutdown state.
LED start-up button Heart Rate Indicating: *Max Heart Rate (MHR) = 180 (default) Zone Color Range (Default) Zone 1 Blue Below 60% MHR Zone 2 Green 61%~70% MHR Zone 3 Yellow 71%~80% MHR Zone 4 Purple 81% ~ 90% MHR Zone 5 Red above 91% MHR Heart rate alarm: if the heart rate exceeds the maximum value, the sensor will vibrate 3 times continuously 3
Power: a. Low Power Aler t: LED flashes red and green alternately,and vibrates once. b. Charging: LED flashes green and will stay on with green when fully charged.
Wearing: Wear armband on the upper portion of the forearm. Sensor should be on the inside or top of forearm. It should be worn snug enough not to move on your arm, but NOT so tight that it restricts arm circulation. Wearing position Initial Setup with BLE Smart Fitness Apps 1. Set BLE on the device to ON. 2. Find the Sensor Settings menu in the BLE Smart Fitness App. 3. Connect the this device armband by turning it on.
5. Applicable models iOS8.0 system version above, iPhone 5s or later. Any BLE 4.2 enabled Android device with Android 4.3 or later. 6. Disclaimer ● The information contained in this manual just for reference. The product described above may be subject to alteration owing to the manufacturer's continuing research and development plans, without making an announcement in advance.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.