User's Manual

How to prolong the battery life of your phone
To have your mobile phone function properly, sufficient battery power is
important. For the power-saving purpose, do the following, if applicable:
Turn off the Bluetooth function of your phone.
Set the backlight level and duration of your phone to a low value.
Turn on the auto keypad lock, turn off the key sounds, tap vibration, or
vibration alerts.
Troubleshooting
The phone does not switch on
Remove/reinstall the battery. Then charge the phone until the battery icon
stops scrolling. Unplug the charger and try to switch the mobile on.
The display shows BLOCKE Dwhen you switch on the phone
Somebody tried to use your phone but didn’t know the PIN code nor the
unblo cking code (PUK) .C ontact your service provider.
The display shows IMSI failure
This problem is related to your subscription. C ontact your operator.
Your phone doesn’t return to idle screen
Long press the hang-up key or switch off the phone, check that the SIM
card and the battery are installed correctly and switch it on again.
The network symbol is not displayed
The network connection is lost. Either you are in a radio shadow (in a
tunnel or between tall buildings) or you are outside the network coverage
area. Try from another place, try to reconnect to the network (especially
when abroad), check that the antenna is in place if your mobile has an
external antenna, or contact your network operator for
assistance/information.
The display doesn’t respond (or the display responds slowly) to key
presses
The display responds more slowly at very low temperatures. This is normal
and does not affect the operation of the pho ne. Take the phone to a
warmer place and try again. In other cases please contact your phone
supplier.
Your battery seems to over heat
You might be using a charger that was not intended for use with your
phone. Make sure you always use the Philips authentic accessory shipped
with your phone.
Your phone doesn’t display the phone numbers of incoming calls
This feature is network and subscription dependent. If the network doesn’t
send the caller’s number, the phone will display Call 1 or Withheld instead.
Contact your operator for detailed information on this subject.