User's Manual

Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
3
Front panel Rear panel
Front panel:
 PIR:The PIR ( Passive Infrared ) is electronic devices which are used in some security alarm
systems to detect motion of an infrared emitting source, usually a human body.
 LENS: Fixed focus lens.
 Infrared LED: Infrared LEDs for night vision.
 Microphone: Built-in microphone.
 Micro SD Card slot: Supports up to 32GB SD card for storing the video.
Rear panel:
 Power Light: If the power supply works fine, the light will be on.
 LAN: 10/100 Mbps RJ-45 port for wired connection
 SoftAP: Press the SoftAP button for more than 2 seconds. The Network light indicator begins to
twinkle every 0.1 seconds.
 WPS/Reset
 WPS: Push both WPS/Reset button on the camera and wireless router within 1 minute, the
camera will connect to the wireless router automatically, in WPS process, the Network light will
blink every 0.4 seconds;
 Reset: Push and hold the WPS/Reset button for more than 10 seconds to set the camera to
factory default, the Power light will blink every 0.4 seconds;
 Power: DC 5V/1A Power supply.
The flashing status of the Power light and Network light are shown in the following table.
Light Flashing Status Description
Power light off The power don't work properly.
on The power supply works fine.
Flashing every 0.4 seconds Reset to take effect
Network light off No Wireless connection
Constant Flash Wired connection
Slow Flash every 1.0 second Wi-Fi connected
Flashing every 0.4 seconds WPS is connecting